Aux Port with Cisco router

Dear All
I post today morning to connect your router with Aux port. To connect Aux port you need modem that support DB-25 Connector to RJ-45(Rollover) cable.
See Below Image Carefully And Remember Points:



Remember Following Points

(1)The AUX port on Cisco routers is either RJ−45 or DB−25. If the AUX port is RJ−45, use a flat−satin rolled RJ−45−−RJ−45 cable (part number CAB−500RJ= ), which is usually provided with every Cisco router for console connections. You also need an RJ−45 to DB−25 adapter marked "MODEM" (part number CAB−25AS−MMOD) to connect the rolled cable tothe DB−25 port on the modem.
(2)If your router has a DB−25 AUX port, use a straight−through DB−25Female − DB25Male
RS−232 cable to connect the modem to the router.

For more information on cabling, see Modem−Router Connection Guide and Cabling Guide
for RJ−45 Console and AUX Ports


Router#show line
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 0 CTY - - - - - 0 0 0/0 -
1 AUX 9600/9600 - - - - - 0 0 0/0 -
2 VTY - - - - - 0 0 0/0 -
3 VTY - - - - - 0 0 0/0 -
4 VTY - - - - - 0 0 0/0 -
5 VTY - - - - - 0 0 0/0 -
6 VTY - - - - - 0 0 0/0 -

Router#
Check AUX lines First.
Now Plan to configure Aux line on router to connect with Terminal.
Router#conf t
Router(config)#line 1
Router(config-line)#modem inout
Router(config-line)#speed 115200
Router(config-line)#transport input all
Router(config-line)#flowcontrol Hardware
Router(config-line)#login
Router(config-line)#password cisco


Thank you,
Regards,
Jignesh